Hi,

I am experiencing an issue with version 4.29, which is the version available on yum for centos6. I am getting the following error: "Unexpected socket close (read_blocking)". This error only occurs once per stunnel instance upon the first connection only. More recent versions of stunnel do not have this problem, but I am hoping to work around this issue on the default version for this OS. My hosts.allow and hosts.deny files are both empty. I have tried adding my services to hosts.allow, but it did not have any noticeble effect.

This is the version that I am using (installed with "yum install stunnel"): $ stunnel -version stunnel 4.29 on x86_64-redhat-linux-gnu with OpenSSL 1.0.1e-fips 11 Feb 2013 Threading:PTHREAD SSL:ENGINE,FIPS Sockets:POLL,IPv6 Auth:LIBWRAP

Global options debug = 5 pid = /var/run/stunnel.pid RNDbytes = 64 RNDfile = /dev/urandom RNDoverwrite = yes

Service-level options cert = /etc/stunnel/stunnel.pem ciphers = FIPS key = /etc/stunnel/stunnel.pem session = 300 seconds stack = 65536 bytes sslVersion = TLSv1 TIMEOUTbusy = 300 seconds TIMEOUTclose = 60 seconds TIMEOUTconnect = 10 seconds TIMEOUTidle = 43200 seconds verify = none

This is what my demonstration setup looks like: nc_client --TCP--> stunnel_client (2000) --SSL--> stunnel_server (2100) --TCP--> nc_server (2200)

Steps to reproduce:

(1) Start the netcat TCP server. $ nc -l 2200

(2) Leave the server open and open a new terminal for the rest of the commands.

(3) Create “client_config.txt” with the following contents: pid = /tmp/client_stunnel.pid debug = 7 output = /tmp/client_stunnel.log client = yes ciphers = ALL fips = no foreground = no

[CLIENT_PROXY_0] accept = 0.0.0.0:2000 connect = 127.0.0.1:2100

(4) Create “server_config.txt” with the following contents: pid = /tmp/server_stunnel.pid debug = 7 output = /tmp/server_stunnel.log client = no ciphers = ALL fips = no cert = /tmp/server_stunnel.pem foreground = no

[SVR_PROXY_0] accept = 0.0.0.0:2100 connect = 127.0.0.1:2200

(4) Start the stunnel client: $ cat client_config.txt | stunnel -fd 0

(5) Start the stunnel server: $ cat server_config.txt | stunnel -fd 0

(6) Send three sequential messages through stunnel to the netcat server: $ echo "Test 1" | nc 127.0.0.1 2000 $ echo "Test 2" | nc 127.0.0.1 2000 $ echo "Test 3" | nc 127.0.0.1 2000

(7) You should see only “Test 3” appear at the netcat server.

“Test 1” will have failed to pass from the stunnel client to the stunnel server and the log will report an "Unexpected socket close (read_blocking)” error. “Test 2” is not the first connection for the stunnel client, so it will pass through to the stunnel server successfully. But because it is the first connection for the stunnel server, it will fail there with the same error. “Test 3” is not the first connection for either the stunnel client or stunnel server, so it will make it through successfully to the netcat server. All subsequent connections will work.

Basically my question is: Is there any way to make this setup work on the first connection with version 4.29, or is a new version necessary?

Thanks, Matthew