Hi Everyone,

I was hoping you could help. I cannot for the life of me get my program to connect through stunnel to this ip address. It appears to connect to stunnel just fine, however I constantly recieve: "connect_blocking" and I've found it very very hard to find information on the internet about this error. Here is the log output below followed by my configuration file:

####LOG####

2011.10.19 09:49:56 LOG7[28234:139956427736816]: local socket: FD=8 allocated (non-blocking mode) 2011.10.19 09:49:56 LOG7[28234:139956427736816]: Service bgcssl accepted FD=8 from 127.0.0.1:58178 2011.10.19 09:49:56 LOG7[28234:139956427839760]: Service bgcssl started 2011.10.19 09:49:56 LOG7[28234:139956427839760]: Option TCP_NODELAY set on local socket 2011.10.19 09:49:56 LOG5[28234:139956427839760]: Service bgcssl accepted connection from 127.0.0.1:58178 2011.10.19 09:49:56 LOG7[28234:139956427839760]: remote socket: FD=9 allocated (non-blocking mode) 2011.10.19 09:49:56 LOG6[28234:139956427839760]: connect_blocking: connecting 148.106.128.90:7631 2011.10.19 09:49:56 LOG7[28234:139956427839760]: connect_blocking: s_poll_wait 148.106.128.90:7631: waiting 10 seconds 2011.10.19 09:50:06 LOG3[28234:139956427839760]: connect_blocking: s_poll_wait 148.106.128.90:7631: TIMEOUTconnect exceeded 2011.10.19 09:50:06 LOG5[28234:139956427839760]: Connection reset: 0 bytes sent to SSL, 0 bytes sent to socket 2011.10.19 09:50:06 LOG7[28234:139956427839760]: Service bgcssl finished (0 left) 2011.10.19 09:50:06 LOG7[28234:139956427839760]: str_stats: 0 block(s), 0 data byte(s), 0 control byte(s)

####CONFIG FILE####

; stunnel.conf

pid = /home/stunnel/bin/stunnel.pid ;setuid = nobody ;setgid = nobody foreground = yes

sslVersion = TLSv1 service = stunnel

client = yes debug = 7 output = stunnel.log

[bgcssl] client = yes accept = 127.0.0.1:12347 connect = 148.106.128.90:7631

Any help would be greatly appreciated.

Regards, Mark