Hi Guys, I am trying to install stunnel-4.05 on Mac 10.2.8. I am following this http://www.stepwise.com/Articles/Workbench/eart.4.0.html article. I am up to Step 8: Testing your setup. The article is old, but I am aware that stunnel 4.* requires a configuration file rather than command line inputs. My config file is [imapd] accept = 993 exec = /usr/local/libexec/imapd execargs = imaps My problem is, when I run (taken from the article) sudo stunnel -c -f -r localhost:993 I get the following, stunnel: command not found Can I use command line arguments here? It seems to be a very non-specific error. While hunting around for an answer I read somewhere else that stunnel likes to die silently? So perhaps I am doing something wrong but getting a vague error message? Is there a log file that I can look at? Thank you for any help, it is appreciated and I hope I've provided sufficient information. Best Regards, Robin