Thank you. It seems that the credentials that were provided were disabled. Everything is working now. Thanks again, [logo1] Paul A. Muller · Systems and Networking Consultant Earnest & Associates · Profitability Improvement Specialists Voice: 305.822.5353 x354 · Fax: 305.822.5848 Email: [email protected]<mailto:[email protected]> · Web: earnestassoc.com<http://www.earnestassoc.com/> · Twitter: @earnestassoc<http://twitter.com/earnestassoc> From: Flo Rance [mailto:[email protected]] Sent: Friday, April 20, 2018 10:06 AM To: Paul Muller <[email protected]> Cc: [email protected] Subject: Re: [stunnel-users] Authentication Hi Paul, IMO, this should be set in your application, not in stunnel.conf. Flo On Fri, Apr 20, 2018 at 3:58 PM, Paul Muller <[email protected]<mailto:[email protected]>> wrote: When I first setup stunnel, I changed my software to reflect the [gmail-smtp] entries in my configuration file. When I tried to send an email from my application I received the following message: “No Email sent, Error 535-5.7.8 Username and Password not accepted.” Then I remarked out the authentication credentials in my software. When I tried to send an email I received the following message: “No Email sent, Error-5.5.1 Authentication Required.” My question is, can place my authentication credentials in the “stunnel.conf” file? And if so, where? Thanks, [logo1] Paul A. Muller · Systems and Networking Consultant Earnest & Associates · Profitability Improvement Specialists Voice: 305.822.5353 x354 · Fax: 305.822.5848 Email: [email protected]<mailto:[email protected]> · Web: earnestassoc.com<http://www.earnestassoc.com/> · Twitter: @earnestassoc<http://twitter.com/earnestassoc> _______________________________________________ stunnel-users mailing list [email protected]<mailto:[email protected]> https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users
